Let's take a look at some of the basic techniques in metal stamping with ImpressArt products.

What you need:

Step 1

Place the steel block on a hard and sturdy surface. Secure the metal strip to the block using tape and the stamp guide to prevent the strip from moving during stamping.

Step 2

Use the stamp guide to evenly space the letters and align the impressions. Write the desired name or message directly on the guide and use the guidelines to space them apart.

Step 3

Hold the punch at a 90° angle to the strip. If it has the ImpressArt logo, make sure it is facing you to ensure that the impression will be made in the correct direction.

Step 4

Gently slide the punch towards the corresponding mark on the guide until you reach its edge.

NOTE - Be careful not to mark the strip while sliding the punch towards the edge of the guide.

TIP - Do not tilt the punch while sliding it to avoid overlapping it with the guide when returning it to a perpendicular position to the strip.

Step 5

Keep the punch firmly against the strip, applying light pressure and resting your hand on the work surface. Strike the punch once with the hammer without applying too much force. Repeat this process until the desired word or message is completed. Finally, remove the guide and tape.

Step 6 - optional

To highlight the impression, colour it with the Paint Marker pen.

Step 7 - optional

If you have difficulty keeping the punch steady, or to protect your fingers, use the Stamp Holder.

Step 8

To punch holes in the strip, use the Hole Punch Tool.